Epoxy specific problems

 Result of reaction with moisture in the air, Resin may have crystallized problems.

 

Resin solid in can

Probable Cause: Resin may have crystallized
Possible Fix: Heat to 120oF until all contents are re-liquefied. Cool to room temperature before mixing with hardener.

 

Surface tackiness

Probable Cause: The hardener is reacting with moisture from the air (also known as blush).
Possible Fix: Purge the hardener container with Nitrogen before placing into storage. Keep the lid closed at all times. Once the hardener is moisture contaminated it can't be fixed. Use fresh product.

 

White, hard spots in Hardener

Probable Cause: Result of reaction with moisture in the air.
Possible Fix: The particles are carboxylic acid and can not be re-liquefied. Filter the material to discard particles.

 

 

Disclaimer
The above information is general in nature and is based solely on experiences by Crosslink Technology Inc. The recommendations provided herein may not be applicable in all situations. They are provided to the recipient as part of our customer service and the user must determine the relevance of the information to his/her application, considering any limitations that may be applicable thereto. Crosslink Technology Inc. does not accept any liability for direct or consequential damages resulting from the the implementations of these recommendations or the use of this information.